NoteAction
xx1500002353
Clean o-rings and o-ring groove on gearbox.3
Inspect the o-rings.
Note
Replace if damaged.
4
GreaseApply some grease on the o-rings.5
Attach the smaller o-ring in the gearbox groove.6
Attach the larger o-ring on the motor flange.7
xx1500002354
Before lifting the motor flange onto the guide pins,
make sure the oil inspection glass is facing at six
o'clock.
8
xx1500002314
Lift the motor flange onto the guide pins.9
Make sure the o-rings are in position and slide
the motor flange into position.
10
xx1600000068
Note
Make sure that the three holes in the gearbox are
covered when the four six-hole washers are fitted.
.
11
Continues on next page
706 Product manual - IRB 8700
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.8.3 Replacing the axis-2 gearbox
Continued
To Next Page
Loading...
