NoteAction
Make sure the o-rings are in position and slide
the motor flange into position.
10
xx1600000068
Note
When the four six-hole washers are fitted, make
sure that the three holes in the gearbox will be
covered. See figure!
11
Attachment screws: M16x130 12.9
Gleitmo 603
xx1500002355
Attach 20 of the 24 attachment screws with the
four six-hole washers.
12
xx1500002356
Remove the guide pins and attach the remaining
screws.
13
Attaching the axis-3 gearbox to frame, step 2
Use this procedure to secure the axis-3 gearbox, together with the motor flange,
to the frame.
NoteAction
Tightening torque: 300 Nm
xx1500002373
Secure motor flange together with the gearbox,
to the frame.
1
Continues on next page
746 Product manual - IRB 8700
3HAC052853-001 Revision: F
© Copyright 2015-2018 ABB. All rights reserved.
4 Repair
4.8.4 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
