ABB IRB 930 - Changing Oil, Axis-2 Gearbox

4.8.3 Changing oil, axis-2 gearbox
Location of oil plugs
The oil plugs of the gearbox are located as shown in the figure.
xx2300000466
Oil plug, filling and ventingA
Oil plug, filling, draining and ventingB
Required tools and equipment
NoteArticle numberEquipment, etc.
The capacity of the vessel must be
sufficient to take the complete amount
of oil.
-Oil collecting vessel
One example of oil dispenser can be
found in section Type of lubrication in
gearboxes on page 100.
-Oil dispenser
Content is defined in section Standard
toolkit on page 596.
-Standard toolkit
Consumable
NoteMaterial
Information about the oil is found in Technical refer-
ence manual - Lubrication in gearboxes.
Lubricating oil
See Type and amount of oil in gearboxes on page 100.
Continues on next page
106 Product manual - IRB 930
3HAC086009-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
4 Maintenance
4.8.3 Changing oil, axis-2 gearbox