ABB IRB 930 - Page 74

Connector kits, outer arm
The table describes the CP/CS and Ethernet (if any) connector kits for the outer
arm.
Art. no.DescriptionPosition
3HAC066098-001M12 CPCS Male straight connect-
or kits
CP/CSConnector kits
3HAC066099-001M12 CPCS Male angled connector
kits
3HAC067413-001M12 Ethernet Cat5e Male straight
connector kits
Ethernet
3HAC067414-001M12 Ethernet Cat5e Male angled
connector kits
Protection covers
Protection covers for water and dust proofing
Protection covers are delivered together with the robot and must be well fitted to
the connectors in any application requiring water and dust proofing.
Always remember to refit the protection covers after removing them.
Note
If the protection covers are not refitted back with the connectors exposed, the
protection class will be lost.
D
C
C
B
A
xx2300000176
Protection covers for air hose connector on the baseA
Protection covers for air hose connector on the process hubB
Protection covers for C2/SMB connector on the base and C1/C2 connector on
the process hub
C
Continues on next page
74 Product manual - IRB 930
3HAC086009-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.2 Customer connections
Continued