Antenna connector
The Connected Services Gateway unit has either an Ability port or an antenna
connector on the front. See installation procedures in section On-site installation
on page 56.
xx1900002450
Customer cable layout
The antenna should go through the cable grommet and fasten on the cabinet.
Note
The end user needs to install proper grommets according to the diameter of the
cables which need to go through the grommet.
Incorrect use of grommets will affect ingress protection, EMI/EMC and
temperature.
It is recommended to use icotek KT grommet.
Ethernet outlet connector, MGMT (Management)
The following type of Ethernet cable is recommended for connection to the Ethernet
outlet connector (MGMT port):
ValueEthernet cable
75 mMaximum length
CAT5e SF/UTPType of cable
Continues on next page
100 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.8 Descriptions for connectors
Continued
To Next Page
Loading...
