5.3.4 Replacing the cable grommet assembly
Location
The illustration shows the location of the cable grommet assembly on the controller.
xx2100000844
Note
The end user needs to install proper grommets according to the diameter of the
cables which need to go through the grommet.
Incorrect use of grommets will affect ingress protection, EMI/EMC and
temperature.
It is recommended to use icotek KT grommet.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
3HAC066396-001Cable grommet asm
3HAC073333-001Harness network connection
2xM12
3HAC074398-001Harness network connection
1xM12
3HAC069954-001Blind plate
3HAC070894-001Harness Ethernet comm. 5xM12
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 414.
-Standard toolkit
Continues on next page
320 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.4 Replacing the cable grommet assembly
To Next Page
Loading...
