ABB OmniCore V250XT - Fitting the Connector for Incoming Mains

3.5.4 Fitting the connector for incoming mains
General
This section describes how to manufacture a cable for connecting the main power
to the controller.
Detailed view
xx2100001257
Description
Cable glandA
O-ringB
Hood, EMCC
Locking lever (x2)D
Connector insertE
Continues on next page
Product manual - OmniCore V250XT 75
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.4 Fitting the connector for incoming mains