5.3.2.1 Replacing the motor connector
Removing the motor connector
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Opening the door on page 176.Open the door.2
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
3
xx2100000318
Removing the motor connector
Note/IllustrationAction
Disconnect the following connectors for
the motor connector:
• T4.X7, T4.X8, T4.X9, T4.X10,
T4.X11, T4.X12, T4.X15
• X1 - K2.X7 & X22
• PE.1 & PE.2
1
Continues on next page
310 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.2.1 Replacing the motor connector
To Next Page
Loading...
