Note/IllustrationAction
xx2100000813
Remove the attachment screws on the
front panel.
2
Push the motor connector into the cabin-
et.
3
Take the motor connector cable out from
the velcro in the cabinet.
Note
Make records about the sequence that
cables are removed. The cables need to
be installed in the same position.
4
Take out the motor connector.5
Refitting the motor connector
Refitting the motor connector
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Continues on next page
Product manual - OmniCore V250XT 311
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.2.1 Replacing the motor connector
Continued
To Next Page
Loading...
