ABB OmniCore V250XT - Replacing the HMI Signal (Flexpendant) Connector

5.3.3 Replacing the HMI signal (FlexPendant) connector
Location
The illustration shows the location of the HMI signal connector in the controller.
xx2100000829
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
Harness-TPU3HAC071006-001Harness TPU connection
Continues on next page
314 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.3 Replacing the HMI signal (FlexPendant) connector