7.3.9 Troubleshooting the process power supply
Location
The process power supply, DSQC 609, is located as shown in the figure below.
xx2100000499
CAUTION
If there are two or more power supply units mounted in a row and too close to
each other, there will be a heating problem and the units can be damaged.
To avoid damaging the power supply units, the units must be separated with 3
pcs of exterior support.
Continues on next page
Product manual - OmniCore V250XT 401
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
7 Troubleshooting
7.3.9 Troubleshooting the process power supply
To Next Page
Loading...
