3.7.9 Installing the mains connections cable
Location
The illustration shows the location of the incoming mains cable gland in the
controller.
xx2100002285
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 414.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC074000-008Circuit diagram - OmniCore
V250XT
Continues on next page
Product manual - OmniCore V250XT 149
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.9 Installing the mains connections cable
To Next Page
Loading...
