3.4.2 Securing and stacking the controller
Securing the controller
The controller can be secured to the ground. The figure below shows the bolt
pattern for the OmniCore V250XT controller. The diameter of the four bolt holes
are 14 mm.
xx2100001275
Stacking the controller
The OmniCore V250XT controller is designed so that a maximum of two controllers
can be stacked on top of each other. The controllers must be safely fixed to each
other, and it must be assured that the opened door on the upper controller does
not cause imbalance.
CAUTION
The stacked controllers must not tilt more than 10 degrees.
58 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.4.2 Securing and stacking the controller
To Next Page
Loading...
