Installing the mains connections cable
The following procedures detail how to connect incoming mains to the controller
through a cable gland.
Note/illustrationAction
xx2100002286
Remove the dust protection lid from the
cable gland (A).
1
A Cable gland
B Incoming mains switch
C Cable pipe
Remove protection from the incoming
mains switch (B).
2
Connecting incoming mains and protective
earth to the controller on page 77.
Connect incoming mains from an external
earth fault protection.
3
Continues on next page
150 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.7.9 Installing the mains connections cable
Continued
To Next Page
Loading...
