Removing the LED indicator
Note/IllustrationAction
xx1900001926
Loose the attachment screws locking the
cable.
1
Remove the terminals (X1&X2) of the
cable from the lamp.
2
Turn the MON_LAMP screw anti-clock-
wise to remove the screw.
3
Take the LED indicator out.4
Refitting the LED indicator
Refitting the LED indicator
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
2
Insert the LED indicator into the cover
from outer side of the door and the screw
from inner side and screw them up.
3
Continues on next page
Product manual - OmniCore V250XT 335
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.6 Replacing the LED indicator
Continued
To Next Page
Loading...
