NoteArticle numberEquipment
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC074000-008Circuit diagram - OmniCore
V250XT
Removing the power cable and power cable cover
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
1
Disconnect the FlexPendant from the
controller.
2
xx1800001189
Remove the attachment screws for the
power cable cover.
3
xx1800001190
Remove the power cable cover.4
Continues on next page
338 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.4.1 Replacing the power cable and power cable cover
Continued
To Next Page
Loading...
