ABB OmniCore V250XT - Page 342

Removing the joystick protection
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
1
Disconnect the FlexPendant from the
controller.
2
xx1800001198
Remove the attachment screws.3
xx1800001199
Remove the joystick protection.4
Refitting the joystick protection
Note/IllustrationAction
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 43.
1
Continues on next page
342 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.4.2 Replacing the joystick protection
Continued