Connecting the power
The following procedure describes how to connect the main power to the controller.
CAUTION
Always inspect the connector for dirt or damage before connecting it to the
controller. Clean or replace any damaged parts.
Action
Connect the main power cable to the incoming mains connector X0 and lock it by
pressing the locking levers.
Tip
When you hear a clear clicking sound, it is locked.
1
xx2100001259
Line fusing
An external circuit breaker (class K) or fuse must be added to prevent short circuit
and overload. The full load current for the robot is marked on the controller name
plate, and is also displayed in section Load current on page 40.
Product manual - OmniCore V250XT 79
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
3 Installation and commissioning
3.5.5 Connecting incoming mains and protective earth to the controller
Continued
To Next Page
Loading...
