ABB SACE Emax 2 Series - Ekip Multimeter Module; External Neutral

To Next Page

To Previous Page

ABB | SACE Emax 2

Electronic accessories | 13 - Other accessories

Ekip Multimeter module

The Ekip Multimeter is a remote viewing unit on the front of the switchgear and is equipped

with a touchscreen display.

It can be installed in the presence of Ekip Dip, Touch, Hi-Touch, G Touch and G Hi-Touch

releases, with which it communicates via Local Bus. It must be powered independently from

the release to which it is connected, and can be powered in AC at nominal 110… 240 V AC,

or DC at nominal 24...48 V DC.

One release can communicate with a maximum of four Ekip Multimeters. On the other hand,

the module can be connected to only one release.

In addition, the module makes an auxiliary voltage of 24 V DC available, which can be used to

power the release. If the release is powered through Ekip Multimeter, the power supply must be

applied directly on the terminal box of the circuit-breaker: in fact the Ekip Multimeter is sized in

order to supply only the release, and therefore it is not able to supply sufﬁcient power to supply

an Ekip Supply module and any other electronic accessories connected to the terminal box.

In the case of connection to an Ekip Touch, Hi-Touch, G-Touch, and G Hi-Touch release, as

well as displaying the measurements, the module also allows you to set parameters and the

protection thresholds.

Further information on the connection of the RC sensor is available at the site http://www.abb.

com/abblibrary/DownloadCenter/, in particular in kit sheet 1SDH001000R0520.

External neutral

This is a current sensor for the neutral conductor outside the circuit-breaker.

It is supported for three-pole circuit-breakers only; it allows the neutral to be protected by

connection to the Ekip release.It’s supplied on request.

Further information on the connection of the external neutral is available at the site http://www.

abb.com/abblibrary/DownloadCenter/, in particular with the sheets:

• 1SDH001000R0506 for E2.2 circuit-breakers

• 1SDH001000R0515 for E4.2 and E6.2 circuit-breakers

Other manuals for ABB SACE Emax 2 Series