ABB SACE Emax 2 Series - Ekip Dip Protection Release; Operator Interface; Introduction; Components of the Interface

ABB | SACE Emax 2
Ekip Dip protection release | 1 - Operator interface
35 | © 2013 ABB | 1SDH001000R0002 - L7804
Ekip Dip protection release
1 - Operator interface
Introduction
The operator interface of the Ekip Dip protection release allows you to:
• Set the parameters relating to the available protections.
• View the status of the release and alarms.
• Connect to the frontal connector to communicate and perform the tripping test.
Components of the interface
The Ekip Dip operator interface appears as follows:
Figure 63
The following table provides a description of the components of the interface:
Position Type Description
A
LED
Protection LED L (alarm and trip)
B Protection LED L (prealarm)
C Protection LED S (alarm and trip)
D Protection LED I (trip)
E Protection LED G (alarm and trip)
F Power LED (release powered and on)
G
Protections:
thresholds
Protection L dip-switch (threshold I1)
H Protection S dip-switch (threshold I2)
I Protection I dip-switch (threshold I3)
L Protection G dip-switch (threshold I4)
M
Protections: times
Protection L dip-switch (time t1)
N Protection S dip-switch (time t2 and type of curve)
Or Protection G dip-switch (time t4 and type of curve)
P Settings Neutral and Frequency dip-switch
Q
Test
Test pushbutton
R Test connector
IMPORTANT: The figure above refers to a an Ekip Dip, LSIG version. In the
case of Ekip Dip versions LI or LSI, LEDs and dip-switches related to the
protections present are available.