ABB SACE Emax 2 Series - Menu; Introduction; Components of the Page

ABB | SACE Emax 2
Ekip Touch protection release | 6 - Menu
65 | © 2013 ABB | 1SDH001000R0002 - L7804
6 - Menu
Introduction
This paragraph illustrates:
• The Menu.
• The structure of the menus.
• How to navigate among the menus
The Menu is the menu access page.
The menus are the level 3 pages that can be displayed on display (see the chapter “1 -
Layout of the interface" and the paragraph "Structure of the pages" on page 57”), and they are
composed of lists of:
• Submenus.
• Parameters that can be set.
• Commands that can be performed.
Selecting a menu item can:
• Open a submenu.
• Open the page Modify Parameter to set a parameter.
• Display scrollable lists of information (e.g. on circuit-breaker, Mainboard, release, connected
modules), measurements in real time, events recorded.
• Open a graphical page (secondary).
• Perform a command (e.g. reset or test).
Components of the page
The page appears as follows:
A B
C
D E
F
G
Protections Advanced Measurements
Settings Test About
Figure 72
The following table provides a description of the various areas of the page:
Pos. Function
A Open the Protections menu.
B Open the Advanced Protections menu.
C Open the Measurements menu.
D Open the Settings menu.
E Open the Test menu.
F Open the Information menu.
G In the presence of messages, open the Alarm List page.