ABB SACE Emax 2 Series - Installation; Warnings and Precautions before the Installation; Mounting of the Fixed Circuit-Breaker; Mounting Anti-Racking Locks

ABB | SACE Emax 2
24 | © 2013 ABB | 1SDH001000R0002 - L7804
Emax E2.2-E4.2-E6.2 circuit-breakers | 6 - Installation
6 - Installation
Warnings and precautions
before the installation
The following warnings and precautions must be respected before installing the circuit-breaker
in the switchgear
WARNING!
• Disconnect the power from the circuit-breaker (power circuit and auxiliary
circuits)
• Make sure the circuit-breaker is disconnected from all sources of energy
• Switch the circuit-breaker to the open position with springs unloaded
NOTE: The trained personnel in charge of handling and lifting must use appropriate
safety equipment.
Mounting of the fixed circuit-
breaker
Fix the circuit-breaker to a horizontal surface using 4 x M10 screws. See Figure 49.
Figure 49
WARNING! E2.2, E4.2 and E6.2 circuit breakers can only be installed in a
vertical position
Mounting anti-racking locks
Before installing the fixed part, it is necessary to fit the lock that prevents the insertion of circuit-
breakers with different electrical characteristics from the fixed part. See Figure 50.
Information on the assembly is available from the web site http://www.abb.com/abblibrary/
DownloadCenter/, in particular with the kit sheet 1SDH001000R0701.
E
2
.
2
N
-
B
-
S
E
2
.
2
H
0
2
0
8
1
0
1
2
1
6
2
0
2
5
0
8
1
0
1
2
1
6
2
0
2
5
LEFT
M
A
T
C
H
A
L
S
O
TH
E
R
I
G
H
T
S
I
D
E
Figure 50