ABB SACE Emax 2 Series - Measurements Menu

ABB | SACE Emax 2
72 | © 2013 ABB | 1SDH001000R0002 - L7804
Ekip Touch protection release | 6 - Menu
Measurements Menu
This menu allows you to:
• Open lists of recorded events.
• Display measurements in graphical or numerical form.
• Reset measurements.
The following table illustrates the submenus and the parameters associated to the menu
Measurements up to Level 3 (if present), and the Ekip Touch releases where they can be
found. The options corresponding to parameters and commands are underlined, to distinguish
from those corresponding to submenus.
Measurements
Options Release
History Data
• Openings: opens a list of the openings performed.
• Events: opens a list of the recorded events.
• Measurements: opens a list of the dimensions with
which the history can be displayed.
Touch
G-Touch
Hi-Touch
G Hi-Touch
Measurement
interval
It opens the Edit Parameters page, to set the standby
time between successive recordings of measurements in
the history.
Power factor It displays the power factor measured.
Touch
(1)
G-Touch
Hi-Touch
G Hi-Touch
Frequency Shows the frequency measured for the voltages.
Energy
• Energy meters: it displays the active, reactive and
apparent energies measured.
• Reset Meters: resets the energy meters.
• Energy RESET: it opens a list of the parameters for
programming resetting of the energy counters (see the
chapter "19 - Operating features", and the paragraph "
Functional specifications", on page 148).
Peak factor
It shows the peak factors measured for the phase
currents and of the neutral.
Touch
G-Touch
Hi-Touch
G Hi-Touch
Harmonic
distortion
Opens the Edit Parameters page, to enable/disable the
alarm with a peak factor greater than 2.1.
Ekip
Synchrocheck
(2)
Opens a list of the measurements related to the
synchronism function.
Touch
(1)
G-Touch
Hi-Touch
G Hi-Touch
Continued on the next page