ABB SACE Emax 2 Series - 6 - Power protections

ABB | SACE Emax 2
Ekip Touch protection release | 6 - Menu
71 | © 2013 ABB | 1SDH001000R0002 - L7804
Test Menu
This menu allows you to access to the commands in order to perform tests.
The following table illustrates the submenus and the commands associated to the menus
Test, up to Level 3 (if present). The options corresponding to commands are underlined, to
distinguish from those corresponding to submenus.
Test
Option
Auto Test Performs a test on the display and LEDs of the interface.
Trip test Enables the opening test
CB test
• Close CB: commands the closing of the circuit-breaker.
• Open CB: commands the opening of the circuit-breaker.
Zone selectivity
(68)
• Protection S: opens a list of the test commands of the
protection.
• Protection G: opens a list of the test commands of the
protection.
Information menu
This menu allows you to view information on:
• Mainboard and release (serial number, model, software version, etc.).
• The circuit-breaker (serial number, rated current, configuration with or without neutral,
number of poles, fixed or withdrawable version or, state, etc).
• The connected electronic accessories (serial number, model if present, software version
if present, information on state if present, etc).
• Date and time.
Information
Function
Protection unit
It displays:
• Information on Mainboard and release.
• Date and time.
Circuit-breaker Displays information on the circuit-breaker.
Modules It displays a list of the electronic accessories connected.
Power Controller
• Load Input Status: shows the Open/Closed status of the
loads.
• Load Active: shows the Active/Inactive status of the loads.