ABB | SACE Emax 2
76 | © 2013 ABB | 1SDH001000R0002 - L7804
Ekip Touch protection release | 6 - Menu
Continued from the previous page
Wave forms
To open the page, from the menu Measurements, you need to select Wave forms, Network
Analyzer, and a quantity in the list. This page shows the wave form of the selected quantity,
acquired at the time of selection, and appears as follows:
F
B
A
C
D
E
95,3V
Voltage 12
Refresh Harmonics
Figure 76
The following table provides a description of the various areas of the page:
Pos. Description
A It cancels the operation, and opens the Wave forms list.
B Quantity selected in the Wave forms list.
C The value of the quantity in position B at the time of selection.
D The wave form of the quantity in position B at the time of selection.
E Refresh key: performs a new acquisition.
F
Harmonics key: available if the measurement of harmonics is enabled
(see the menu Settings, Network Analyzer), open the Harmonic
Measurements page.
Continued on the next page
To Next Page
Loading...
