ABB | SACE Emax 2
Ekip Touch protection release | 7 - Insertion of the password
79 | © 2013 ABB | 1SDH001000R0002 - L7804
Continued from the previous page
NOTE:
• If you are changing the password, after the first confirmation of the new password, the
page opens again for the reconfirmation.
• In the case of an incorrect password, the message “Wrong Password” appears for
approximately 3 seconds, and the page for insertion of the password will open again.
• There is no limit to the number of incorrect passwords that you can insert.
• If the password is lost, it can be reset by inserting the Maintenance Password, calculated
from the serial number of the circuit-breaker, and which can be recovered using the Ekip
Connect application on a page reserved for Service: contact ABB.
To Next Page
Loading...
