ABB tacteo KNX - Page 181

Index
Product manual 2CKA001473B9482
│
181
Setpoint settings — Setpoint temperature for cooling
comfort (°C) .......................................... 108
Setpoint settings — Set-point temperature for frost
protection (°C) ....................................... 108
Setpoint settings — Set-point temperature for heat
protection (°C) ....................................... 109
Setpoint settings — Setpoint temperature for heating
and cooling comfort (°C) ........................... 107
Setpoint settings — Setpoint temperature for heating
comfort (°C) .......................................... 107
Setting the temperature unit via object ............... 72
Settings of basic load ................................... 103
Settings of basic load — Minimum control value for
basic load > 0 ......................................... 103
Setup and function ........................................ 15
Software .................................................... 27
Summer compensation.................................. 123
Summer compensation — (Lower) Starting temperature
for summer compensation (°C) .................... 124
Summer compensation — Offset of the set-point
temperature for the entry into summer
compensation (x 0.1°C) ............................. 124
Summer compensation — Offset of the set-point
temperature for the exit from summer
compensation (x 0.1°C) ............................. 125
Summer compensation — Summer compensation ... 123
Support rings ............................................... 17
Switching On and Off ..................................... 35
Switch-off delay ......................................... 160
Switch-off pre-warning ................................. 161
Switchover time via object .............................. 62
T
Target group ............................................... 12
Technical data ............................................. 19
Temperature ............................................. 176
Temperature reading — Adjustment value for internal
temperature measurement (x 0.1°C) ............. 116
Temperature reading — Control value for fault (0 -
255) .................................................... 116
Temperature reading — Cyclic sending of actual
temperature (min) ................................... 115
Temperature reading — Difference of value for sending
the actual temperature (x 0.1°C) ................. 115
Temperature reading — Inputs of temperature reading
......................................................... 113
Temperature reading — Inputs of weighted
temperature reading ................................ 114
Temperature reading — Monitoring time for
temperature reading (0 = no monitoring) (min) . 116
Temperature reading — Weighting of external
measurement (0 to 100%) ........................... 114
Temperature reading — Weighting of external
measurement 2 (0 to 100%)......................... 115
Temperature reading — Weighting of internal
measurement (0 to 100%) ........................... 114
Temperature unit ......................................... 71
Threshold between Zone 2 and 3 (%) ................. 131
Threshold between Zone 3 and 4 (%) ................. 132
Time for automatic ending at overwrite download ... 56
Time for automatic ending of the alarm ............... 55
Time for automatic ending via object .................. 56
Time for switch-off pre-warning ...................... 162
U
Updating options .......................................... 29
Use of automatic enable/blockage ..................... 61
V
Value ...................................................... 176
Value (%).................................................. 176
Value 1/Value 2 ........................................... 69
Value 2 ...................................................... 70
Value for cyclic sending ................................ 145
Value for switch-off prewarning ...................... 162
Value of the output object for logic true ............ 151
Value of the output object for logic untrue ......... 152
Versions ..................................................... 16
W
Waiting period for display of actual temperature .... 73