113 SOUND PARAMETERS REFERENCE
Semitone
Accessible from the panel via the SEMITONE knob.
> -48 to +48 semitones: The nominal pitch of oscillator 1.
Modulation destination “Osc1 Pitch“.
Key Follow
> -64 to +31, Norm, +33 to +63: How much the pitch of oscilla-
tor 1 follows the keyboard (i.e. MIDI note number). Press both
VALUE buttons at the same time for normal tuning (Norm).
Balance
Accessible from the panel via the OSC BALANCE knob in the
MIX section.
> -64 to +63: Adjusts the relative levels of oscillator 1 and oscil-
lator 2 (including FM), whereby -64 is oscillator 1 only and +63
is oscillator 2 only. Note that this parameter is mirrored in the
oscillator 2 menu. Modulation destination “Osc Balance”.
HyperSync
Accessible from the panel via the SYNC button.
> Off, On: Switches oscillator 1 HyperSync off/on. See “About
HyperSaw and Sync” on page 107.
H-Sync Offset
Accessible from the panel via the FM AMOUNT knob.
If HyperSync (see above) is set to Off, this parameter will not be
available.
> 0 to 127: The frequency offset of any HyperSaw (both oscilla-
tor 1 or 2) with respect to its own internal “master” oscillator.
Modulation destination “FM/HyperSync”.
To Next Page
Loading...
