110
OSC3 ON
Activates/deactivates oscillator 3. If oscillator 3 is not active, it
will be skipped when pressing the SELECT button.
See “Oscillator 3” on page 120.
MONO
Toggles between the most recently selected “Mono” key mode
(see “Key Mode” on page 122) and polyphonic operation. To
step through all key modes, hold SHIFT and press MONO
repeatedly.
SYNC
This activates/deactivates oscillator synchronization (oscillator
2 to oscillator 1) if oscillator 2 is in Classic mode. This button
has no effect on oscillator 2 is in HyperSaw or WaveTable
mode.
If oscillator 1 mode is a HyperSaw, switching SYNC on acti-
vates oscillator 1 HyperSync instead. See “About HyperSaw
and Sync” on page 107.
PANIC
Via MONO + SYNC. Resets any “hanging” notes.
FM AMOUNT
Classic or WaveTable: Controls the intensity of frequency mod-
ulation.
HyperSaw: Controls the HyperSync Offset parameter i.e. tunes
the HyperSaw oscillators upwards relative to their own (inaudi-
ble) sync oscillators. See “About HyperSaw and Sync” on
page 107.
FM MODE
Via SHIFT + FM AMOUNT. Specifies the FM modulator source.
See “FM Mode” on page 116.
Oscillator 1 – Classic
The following information applies to oscillator 1 in Classic
mode only.
>EDIT MENU
To Next Page
Loading...
