153 CONFIGURATION REFERENCE
Soft Thru
> Off, On: Specifies whether received MIDI data is also directly
routed to (i.e. mirrored at) the MIDI out socket. Before switch-
ing this parameter on, make sure there will be no MIDI loop in
your system.
MIDI Device ID
> 1 to 16, Omni (17): Identification number for transmitting/
receiving System Exclusive data (see glossary). To allow
SysEx communication between two devices, they must be
set to the same device ID. If set to Omni, the Virus will receive
Sysex data with any ID, and transmit with ID = 17.
Arp Note Send
> Off, On: Specifies whether the notes created by the arpeggia-
tor (see “Arpeggiator” on page 76) will be sent to the MIDI
output instead of the original played notes.
MIDI Clock
> Internal Sync: Any received MIDI Clock will be ignored. An
internally generated clock is used instead.
> Sync to External: Received MIDI Clock will be recognized.
This is the standard setting.
>Send: Internally generated MIDI Clock is sent to the MIDI out-
put.
MIDI Volume
> Disabled, Enabled: Specifies whether MIDI CC#7 (volume)
will be recognized.
Program Change
> Disabled, Enabled: Specifies whether the MIDI message
“Program Change” will switch Single programs. This applies
to programs in Single mode as well as PARTs in Multi or
sequencer mode.
To Next Page
Loading...
