Access Virus TI - Oscillator 2 - Hypersaw

117 SOUND PARAMETERS REFERENCE
> Off, On: Activates/deactivates oscillator synchronization.
Whenever oscillator 1 starts a new cycle, oscillator 2 resets its
phase (see “Phase angle” in the glossary).
FiltEnv>FM
> -64 to +63: Controls how much filter envelope is applied to
FM Amount. This was implemented in previous Virus models
to facilitate FM sweeps, and has been retained for compatibil-
ity reasons. Modulation destination “FiltEnv>FM/Hsync“.
Oscillator 2 – HyperSaw
Mode
Accessible from the panel via SHIFT + oscillator SHAPE.
> Classic, HyperSaw, WaveTable: Selects the basic type of
oscillator.
Density
Accessible from the panel via the oscillator SHAPE knob.
>1.0 to 9.0: The number of sawtooth waves used. The volumes
are cross-faded for completely smooth transitions. Modula-
tion destination “Osc2 Shape“.
Spread
Accessible from the panel via WAVE SELECT/ PW.
> 0 to 127: Nominal detuning between individual waves in the
HyperSaw. Modulation destination “Osc2 Pulse Width“.
Semitone
As in oscillator 1 – see “Semitone” on page 111. Modulation
destination “Osc2 Pitch“.