89 SOUND PARAMETERS REFERENCE
EFFECTS (upper row)
The upper half of the Effects section is responsible for delay,
reverb and 3-band equalisation, all of which can be applied
simultaneously.
SELECT
Determines whether the three knobs apply to DELAY, REVERB
or one of the EQ bands, and which menu will appear when the
EDIT button is pressed once.
EDIT
Opens the menu for DELAY, REVERB or one of the EQ bands,
depending upon which of these is currently selected.
SEND, EQ GAIN
If DELAY or REVERB is selected, this is an effect send control
(dry/wet mix). If one of the EQ bands is selected, this knob con-
trols the Gain parameter.
TIME / COLOR, EQ FREQ
If DELAY or REVERB is selected, this is usually a Time control.
However, if one of the synchronized modes is selected (see
“Clock” parameters below), it controls the Coloration parameter
instead. If an EQ is selected, it controls the Frequency parame-
ter.
FEEDBACK / DAMPING, EQ Q-FACTOR
If DELAY is selected, this is a feedback control. The same
applies for REVERB modes with feedback (see “Mode” on
page 92), otherwise it is a Damping control (see “Damping” on
page 93). If the MID EQ band is selected, it controls the MID EQ
Q-Factor (see “Q-Factor” on page 94). If LOW or HIGH EQ is
selected, this knob is inactive.
SHIFT+TIME/COLOR as well as SHIFT+FEEDBACK/DAMPING
will control the “other” parameter if both are available in the
selected effect.
>PANEL CONTROLS
To Next Page
Loading...
