88
> Osc1+2 Pulse Width: The pulse width of both oscillators at
the same time.
>Osc2 Pulse Width: The pulse width of oscillator 2.
> Sync Phase: When Sync is switched on (see “SYNC” on
page 110), this defines the absolute phase of oscillator 2
each time it is reset by oscillator 1. Modulating Sync Phase
can cause effects similar to pulse width modulation, thus
giving the (typically rather cold) sync-sounds more warmth.
Amount
> 0 to 127: How much LFO3 modulates the selected target.
Note that, unlike the other LFOs, this is a unipolar parameter.
Modulation destination “LFO3 Assign Amt“.
To Next Page
Loading...
