Access Virus TI - Reverb

91 SOUND PARAMETERS REFERENCE
Feedback
> 0 to 127: For repeated delays. Determines how much of the
output signal is fed back into delay input, affecting the
number of audible repeats. Modulation destination
“Delay Feedback“.
Coloration
> -64 to +63: Applies progressive filtering within the feedback
path (see “Feedback” above). Negative values make repeats
successively mellower, whereas positive values make them
brighter. Modulation destination “Delay Coloration”.
The Delay effect has its own dedicated LFO for modulating the
delay time. Note that this can cause interesting pitch modula-
tion and stereo effects.
Mod Rate
> 0 to 127: The speed of the delay LFO. Modulation destination
“Delay Mod Rate“.
Mod Depth
> 0 to 127: The amount of modulation applied to Delay Time by
the delay’s own LFO. Note that the left and right channels are
affected differently, so this parameter can be used to create
stereo effects.
Modulation destination “Delay Mod Depth”.
Mod Shape
> Sine, Triangle, Sawtooth, Square, S&H, S&G: The delay
LFO’s waveform. Use S&G for “tape echo” type effects.
Reverb