109 SOUND PARAMETERS REFERENCE
MODE
Via SHIFT + SHAPE knob. Selects the type of oscillator
(Classic Virus, HyperSaw or WaveTable).
WAVE SELECT/ PW
Classic: Either selects one of the 64 spectral waves or controls
Pulse Width, depending on the current value of SHAPE. See
“Wave Select or Pulse Width” on page 111 for details.
HyperSaw: Controls the Spread parameter. See “Spread” on
page 112.
WaveTable: Selects a Table. See “Table” on page 114.
SEMITONE
Controls oscillator pitch (see “Semitone” on page 111). While
turning the knob, pitch is automatically smoothed so that
SEMITONE appears to be a continuous frequency control.
PORTAMENTO
Via SHIFT + SEMITONE. How slowly the pitch of one note
glides to the next. This parameter is not available in the oscilla-
tors menu, but in the Master Edit menu. This is because it is
also applied to filter frequency – see “Portamento” on page 122.
DETUNE 2/3
Fine-tunes either oscillator 2 upwards or oscillator 3 down-
wards, depending upon which oscillator is currently selected.
See “Detune” on page 121.
UNISON DETUNE
Via SHIFT + DETUNE. Direct access to the “Unison Detune”
parameter (also available in the Master edit menu – see
“Detune” on page 131).
SELECT
Switches between the three oscillators so that the upper row of
knobs (SHAPE, WAVE SELECT/ PW, SEMITONE and
DETUNE 2/3) will apply to the newly selected oscillator. The sta-
tus of SELECT also determines which menu will be opened
when the EDIT button is pressed...
EDIT
Opens the ocillators menu for the currently selected oscillator.
Pressing EDIT again toggles between this menu and parameters
that are common to all oscillators (see “Common” on page 121)
as well as Sub Oscillator, Noise and Ring Modulator settings.
To Next Page
Loading...
