Access Virus TI - Page 108

108
Here is a table showing how oscillator mode selection deter-
mines what the SYNC button, the FM AMOUNT knob and
SUB OSCILLATOR knobs actually do...
SHAPE
Classic: Blends the waveforms available within each oscillator.
See “Shape” on page 111.
HyperSaw: Controls the Density parameter – the number of
sawtooth waves used. See “Density” on page 112.
WaveTable: Controls the Index parameter – the nominal posi-
tion within the Table. See “Index” on page 114.
Osc 1 Mode Osc 2 Mode SYNC Button on FM AMOUNT knob SUB OSCILLATOR knob
Classic Classic Active sync FM amount Sub Oscillator volume
Hypersaw OSC2 HyperSync offset Sub Oscillator volume
Osc2 HyperSub mix
Wavetable FM amount Sub Oscillator volume
Hypersaw Classic Activates Osc 1 HyperSync
Activates sync
Osc1 HyperSync offset
FM amount
Osc2 HyperSub mix
Hypersaw Activates Osc 1 HyperSync Osc1 HyperSync offset
Osc2 HyperSync offset
Osc1 HyperSub mix
Osc2 HyperSub mix
Wavetable Activates Osc 1 HyperSync
Deactivates FM
Osc1 HyperSync offset or
FM amount
Osc1 HyperSub mix
Wavetable Classic Activates sync FM amount
Hypersaw Osc2 HyperSub mix
Wavetable FM amount