162
BPM LED Brightness
> 0% to 100%: Relative brightness of the BPM LED.
LED Mode
Specifies what the LFO1 and LFO2 LEDs at the top of the
MODULATORS section will indicate.
> LFO: The default value. LED intensity follows LFO oscilla-
tion.
>Ext Inputs: LED intensity shows the level of external input.
>Auto: Either of the above, depending on whether there is a
signal at the inputs.
> Output1, Output2, Output3: LED intensity shows output
levels.
> Voice Steal: Indicates note-stealing (see glossary). LED
intensity follows the immediate levels of notes being stolen.
Mem Protect
>Disabled: Data can be stored.
>Enabled: Full memory protect – no data can be overwritten.
LCD Contrast
> 0 to 127: Optimize the display for different viewing angles.
Remote Mode
Determines what the MASTER VOLUME knob will control in
while in Remote mode (see “REMOTE” on page 125).
>Volume>Virus: As in the other modes i.e. it will control out-
put levels of the Virus.
>Volume>MIDI: The MASTER VOLUME knob will send MIDI
CC#7 (Volume) data.
To Next Page
Loading...
