99 SOUND PARAMETERS REFERENCE
> Off, 1 to 127: Cross-fade between the dry and wet signal. Set
this to 64 for normal phasing (together with zero Feedback -
see below). Modulation destination “Phaser Mix“.
Frequency
> 0 to 127: The average frequency of resonant peaks (see
Spread below). Modulation destination “Phaser Frequency“.
Feedback
> -64 to +63: The amount of signal fed back into the Phaser
input, causing a resonance effect. The Feedback parameter is
bipolar because positive and negative values result in differ-
ent tonal characteristics. Modulation destination
“Phaser Feedback“.
Mod Rate
> 0 to 127: Modulation rate – the speed of the Phaser’s dedi-
cated LFO (a triangle wave) used to modulate the Frequency
parameter (see above). Modulation destination
“Phaser Mod Rate“.
Mod Depth
> 0 to 127: How much the Frequency parameter (see above) is
modulated by the Phaser’s LFO. Modulation destination
“Phaser Mod Depth“.
Stages
>1 to 6: The number of all-pass filters used in the Phaser. This
value affects the complexity of the phased signal.
To Next Page
Loading...
