5-3 USB Driver Upgrade
Procedure
1. Set-up
- Press "Power" and "MENU" at the same
time ,then plug in power cord to the
Projector and hold on about 5 seconds.
- Once the Temp and the Lamp LED light
up, plug in USB cable into the projector
and link to the USB port of a PC.
2. Execute Program
(1) "Found new hardware wizard" will be
appearred on the screen.
(2) Select "Install the software automatically
(Recommended)".
(3) Then click "Next".
3. Finish
- Click "Finish" to end the installation.
(2)
(3)
To Next Page
Loading...
