ADTECH4 SeriesCNC Maintenance Manual
variable frequency rotation corresponding to analog 10V, and transfer the
rotation directly later, while the controller will output corresponding
analog voltage according to linear scale automatically.
Spi.Gear Denominator (CMD)
If the principal axis has gear position, please set the hardware gear ratio
to this parameter, which hasn’t been used in standard version, but may be
used in certain special conditions.
Set the delay before next action or operation after forward or reverse
rotation of the principal axis.
Servo principal axis ready level
Servo principal axis stop place level
Servo principal axis zero speed in place level
Servo principal axis speed arrival level
To Next Page
Loading...
