Adtech ADTECH4 CNC Series - 3.4 Operating Keys

ADTECH4 SeriesCNC Maintenance Manual
3.4 Operating Keys
The keys of CNC4 system are defined below:
Key
Purpose
[RESET]
Cancel alarm, reset CNC
Address/number keys
Enter letters, numbers, etc.
[EOB], [CAN]
Confirm or cancel operation
[EOB], [CAN], [DEL]
Program edit (insert, delete, modify)
Mode switch key
Select operating mode
Cursor moving key
Four keys are available: Up/Down: adjust ration, move
cursor between subsections; Left/Right: move cursor to
left/right
Page key
Up/Down: Turn pages
Menu keys
Select the menus
Principal axis forward
Press it and the principal axis rotates forward, press it
again and the principal axis stops
Principal axis reverse
Press it and the principal axis rotates reversely, press it
again and the principal axis stops
Coolant
Coolant ON/OFF
Lubricant
Lubricant ON/OFF
[BDT]
BDT function ON/OFF
[SBK]
SBK function ON/OFF
[PAUSE]
Pause automatic operation
[START]
Start automatic operation