ADTECH4 SeriesCNC Maintenance Manual
9.4
File Management
In the file management interface, you can manage the system files.
To enter file management interface:
File management mainly has the following functions:
Connect the UBS disk, and copy the files between USB disk and electronic disk;
Upgrade system software: Copy the upgrade file to system memory in either method above to upgrade the
software;
Restart the controller. In [File Management] interface, press the Reset key to restart the controller. This
method is different from restarting due to power failure. In certain occasions, you can restart the controller
quickly in this method to make certain function take effect.
Connect to PC with the USB cable, and exchange the data between USB disk and PC.
File operation interface is shown below:
File Operation Interface
To Next Page
Loading...
