ADTECH4 SeriesCNC Maintenance Manual
Specifying principal axis fails
Specified arc doesn’t exist
X instruction missing error
Y instruction missing error
Z instruction missing error
A instruction missing error
B instruction missing error
C instruction missing error
D instruction missing error
R instruction missing error
F instruction missing error
T instruction missing error
S instruction missing error
P instruction missing error
M instruction missing error
G instruction missing error
I instruction missing error
J instruction missing error
K instruction missing error
Q instruction missing error
Screw distance repeat designation error
System alarm occurs and exits abnormally
Exit through human intervention
G code parameter source isn’t specified
G code program No. table storage address isn’t specified
To Next Page
Loading...
Need help?
General
