Adtech ADTECH4 CNC Series

To Next Page

To Previous Page

ADTECH4 SeriesCNC Maintenance Manual

4.6 Tool setting ............................................................................................................................. - 28 -

4.6.1. Centered (M series) .................................................................................................................................... - 28 -

(1) Single axis centered........................................................................................................... - 28 -

(2) Square centered ................................................................................................................ - 29 -

(3) Plane circle (XY plane) centered ..................................................................................... - 29 -

4.6.2. Tool regulator (M series) ............................................................................................................................ - 31 -

4.6.3. Tool setting by test cutting (L series) .......................................................................................................... - 32 -

4.7 Data settings ........................................................................................................................... - 33 -

4.7.1. Tool compensation data setting .................................................................................................................. - 33 -

4.7.2. System parameter setting ............................................................................................................................ - 34 -

4.8 System shortcuts ............................................................................................................................. - 35 -

5. Automatic Operation ...................................................................................................... - 36 -

5.1 Memory Operation ................................................................................................................. - 36 -

5.2 MDI Operation ....................................................................................................................... - 36 -

5.3 USB disk DNC ....................................................................................................................... - 37 -

5.4 Speed rate adjustment ............................................................................................................. - 37 -

5.5 Run idle .................................................................................................................................. - 37 -

5.6 SBK Function ......................................................................................................................... - 38 -

5.7 BDT function .......................................................................................................................... - 38 -

5.8 Stopping Automatic Operating ............................................................................................... - 38 -

6. Safe Operation ................................................................................................................. - 40 -

6.1 Emergency Stop ..................................................................................................................... - 40 -

6.2 Hard Limit Over Travel .......................................................................................................... - 40 -

6.3 Soft Limit Over Travel ........................................................................................................... - 40 -

7. Alarm and Self-diagnosis Function ............................................................................... - 41 -

7.1 NC Program Execution Alarm................................................................................................ - 41 -

7.2 System Environment Alarms .................................................................................................. - 43 -

7.3 Alarm processing .................................................................................................................... - 45 -

7.4 Self-diagnosis ......................................................................................................................... - 45 -

8. Program Saving & Editing ............................................................................................. - 46 -

8.1 Saving the Program in the Memory........................................................................................ - 46 -

8.1.1. Keypad Input (New Program) .................................................................................................................... - 46 -

Main Page

Adtech ADTECH4 CNC Series - Page 6

Table of Contents

Related product manuals