AEM SM100 - Page 70

Maintenance
7.2 Maintenance Label
70
Operator’s Manual | SM100 | 5100064108 | 08/2022 | [en-US]
Symbol Task Reference
Replace engine oil and filter.
[}85]
Check lift arm support device for damage.
[}65]
Check condition of all drive belts. Adjust or replace as needed.
[}87]
Check and clean radiator fins.
[}91]
Every 500 Operating Hours (Once a Year)
Replace the fuel filter.
[}94]
— Clean the water separator.
[}81]
Every 1000 Operating Hours
Replace the hydraulic tank filler cap.
[}96]
Replace the hydraulic fluid and filter.
[}96]
Check and adjust the engine intake and exhaust valve clearance.
1)
—
Every 2000 Operating Hours
— Change coolant. Check and replace coolant hoses.
2)
—
— Check fuel hoses and tubelines for damages and leaks. Repair or replace as needed.
2)
—
1) This maintenance task should be performed by a qualified technician. Contact an authorized YANMAR industrial engine dealer or distributor
for assistance.
2) This maintenance task should be performed by a qualified technician. Contact an authorized Wacker Neuson dealer or service center for as-
sistance.