Diagnostic and Error Messages 4ā31
Bypassing Boot Errors
If you encounter an error code numbered 100 or above, try to bypass
it. The system will attempt to complete its bootup.
To bypass boot errors:
1. Restart the imagesetter.
2. When the boot error is detected, an error icon and the Plus
button appear on the screen.
3. Press Plus within ten seconds. The imagesetter will attempt to
complete its bootup.
If the system cannot bypass the error and complete its bootup, make
note of the error message and call for service.
ā Note: It is recommended that you report diagnostic errors even if
you can bypass them. Diagnostic errors indicate there is a problem
with your system that eventually will cause it to fail.
To Next Page
