Using the Imagesetter Control Panel 2–41
Storing Supply Cassette Parameters
You can define up to five different sets of supply cassette parameters
and store each of them under its own cassette program number. If you
define and use cassette parameters, you can change a group of
parameters on the SelectSet Avantra imagesetter just by selecting a
different cassette program number.
Consider this example:
A shop uses film in three different widths. Operators frequently need
to change film width. Cassette 1 is loaded with 16-inch (305 mm),
cassette 2 is loaded with 24-inch (355 mm), and cassette 3 is loaded
with 36-inch (458 mm) film. When changing supply cassettes, the
operator changes the cassette number at the control panel. The
imagesetter reads the stored parameters from memory.
Consider these advantages:
n Save time by not having to key in a new set of parameters.
n Reduce the chances of operator error.
n Easily track media remaining in a cassette.
To Next Page
Loading...
Need help?
General
