Using the Imagesetter Control Panel 2–49
Definition of Utilities Functions
Retract Punches and Nips: Rollers, called nip rollers or supply rollers,
and punches hold media in place. Press Retract Punches and Nips to
release media. Use this function to clear jammed media.
Cut: Cuts media with no media feed. Before the imagesetter makes the
cut, it checks to make sure that at least 6 in. (15.3 cm) has been fed
past the cutter. This prevents you from cutting a short piece of media
that could slip between the feed rollers and cause a jam.
Feed: Feeds the amount of media specified by Feed Amount in the
Feed Amounts screen.
To Next Page
Loading...
