2ā38 SelectSet Avantra Series Control Panel and Operating Guide
Definition of Cassette Setup Functions
Select Supply: The supply cassette to be used.
Cassette Number: The number of the cassette program that contains
the preset supply cassette parameters for the selected supply cassette.
See Storing Supply Cassette Parameters later in this section.
Media Type: Type of media (film, plate, or paper) in the selected
supply cassette.
Punches: Whether punches are enabled or disabled. For Avantra 20
and 36: head punches only. For Avantra 25, 30, and 44: head
punches, tail punches, or head and tail punches.
Media Thickness: Thickness of the media in the selected supply
cassette.
Media Amount: Amount of media (length of media remaining on the
media roll) in the selected supply cassette.
Media Width: Width of media in the selected supply cassette.
Exposure: Resolution and density range to be used for imaging.
Test Page: The resolution and exposure increments to be used for
imaging the test page. See the Exposure Tests section in this user
guide.
Image Offset: Lets you set an amount by which an image will be
offset from the left side of the media. You can use this fine-tuning
adjustment to move the image on a plate, so that the transfer punches
do not make holes in the image.
ā Note: On some models, certain functions, such as dual supply
cassettes and media punches, are extra-cost options. If an option
is not installed, the icon that controls it is grayed out (dimmed).
To Next Page
Loading...
