1–16 SelectSet Avantra Series Control Panel and Operating Guide
General Safety Instructions
n The imagesetter should be installed near a wall outlet, and the
outlet should be easily accessible.
n Before cleaning, turn off the power, then unplug the imageset-
ter from the wall outlet. Clean only with a damp cloth. Do not
use liquid or aerosol cleaners.
n Do not use the imagesetter in any area near water. Keep all
liquids off the top of the imagesetter to prevent spills.
n Slots and openings in the enclosure provide ventilation. To
ensure reliable operation, these openings must not be blocked.
Install the imagesetter at least 12 in. (31 cm) away from walls.
(Optimum clearance is 24 in. or 61 cm.) Do not place objects
between the imagesetter and the wall.
n Make sure that the imagesetter is connected to the correct
power source. This information is indicated on the model tag.
n The imagesetter must be electrically grounded to ensure conformance
to safety requirements. It comes with a 3-wire grounding plug, which
has a grounding pin. If this plug does not fit your electrical outlet,
have a qualified electrician replace the obsolete outlet.
n Never allow objects of any kind into the imagesetter through the
enclosure vents. Objects may come in contact with hazardous
voltage, which could create a risk of fire or electric shock.
n Do not attempt to service the imagesetter yourself, except as
specifically explained in the user documentation that comes
with it. Opening and removing covers may expose you to
dangerous voltage and radiation hazards.
n Unplug the imagesetter from the wall outlet and place a service
call under these conditions:
The power cord is damaged or frayed.
Liquid has been spilled into the imagesetter.
The imagesetter has been physically damaged.
The imagesetter does not operate normally, even when you
follow the operating instructions.
To Next Page
